Do buses transporting Vermont students to and from school (or in connection to school activities) need to be registered in this state?

There is a lot of confusion regarding the titles and registration of Skoolie, Shuttle, and Box Van Conversions. The laws vary from state to state, in order to convert an old school bus into an RV/Motor Home you must meet the following requirement:

Vermont Law 32 VSA §8902(11) defines a “Motor Home,” it states:

“means a new or used pleasure car designed to provide temporary living quarters, built into the integral part of,  or permanently attached to, a self-propelled motor vehicle chassis or van.  The vehicle must contain at least four of the following facilities; cooking, refrigeration or icebox, self-contained toilet, heating and/or air conditioning, a portable water supply system including a sink and faucet, separate 110-125 volt electrical power supply, and/or an LP gas supply.”

If it does not have four of these items the use of the vehicle cannot be changed from a bus/school bus to an RV.  Just taking out a “few seats” and adding “some beds” does not in itself change the purpose of the vehicle. You would still need to install at least four more of the above items. If you fail to do that the vehicle’s purpose would remain a school bus which would require the operator to have the appropriate license and endorsements. 

Additionally; the vehicle must be painted a color different than school bus yellow and the eight-way light system must be removed.  

According to the National Highway Safety Transportation Administration:

“Students are about 70 times more likely to get to school safely when taking a bus instead of traveling by car. That’s because school buses are the most regulated vehicles on the road; they’re designed to be safer than passenger vehicles in preventing crashes and injuries; and in every State, stop-arm laws protect children from other motorists.

Seat belts have been required on passenger cars since 1968, and 49 States and the District of Columbia have enacted laws requiring the use of seat belts in passenger cars and light trucks. There is no question that seat belts play an important role in keeping passengers safe in these vehicles. But school buses are different by design, including a different kind of safety restraint system that works extremely well.

Large school buses are heavier and distribute crash forces differently than passenger cars and light trucks do. Because of these differences, bus passengers experience much less crash force than those in passenger cars, light trucks, and vans.

NHTSA decided the best way to provide crash protection to passengers of large school buses is through a concept called “compartmentalization.” This requires that the interior of large buses protect children without them needing to buckle up. Through compartmentalization, children are protected from crashes by strong, closely-spaced seats that have energy-absorbing seat backs.

Small school buses (with a gross vehicle weight rating of 10,000 pounds or less) must be equipped with lap and/or lap/shoulder belts at all designated seating positions. Since the sizes and weights of small school buses are closer to those of passenger cars and trucks, seat belts in those vehicles are necessary to provide occupant protection.”

Some states have passed legislation requiring school buses to have seatbelts in them.  As of now, Vermont has not.  Some school districts and/or transportation providers have also mandated seatbelts be in the school buses they use.

No. DMV policy states "School bus mechanics will be required to possess, at a minimum, a Class B CDL with a "P" (passenger) endorsement to operate an empty school bus." This applies only to inspection of Type I School Buses. For Type II School Buses the inspection mechanic does not need a CDL or a Type II School Bus endorsement.

If the driver meets all qualifications for a Vermont Type II School Bus endorsement a card will be issued to the individual allowing them to drive a Type II School Bus in this state. These requirements include attending a Vermont school bus clinic, passing all required tests (knowledge, vision, and skill tests), and submitting a medical form.

No, the "S" (school bus) endorsement must be added by the state of issue.

Yes, if their license has both an "S" (school bus) and "P" (passenger) endorsement. There are no additional requirements.

Type I School Buses must be National School Bus Glossy Yellow. It is legal for the hood and fenders to be lusterless black. Type II School Buses, manufactured after January 1, 2000, must be painted school bus yellow.

The School Board has the authority and responsibility to establish bus routes and stops. The school bussing coordinator should also be consulted. When the stop is on a state highway, the Vermont Agency of Transportation can be consulted and may send someone out to look at the stop and put up a sign if warranted.

In order for a school bus to obtain a municipal registration it must be owned by a municipality and used entirely by that municipality or any other municipality. A municipality may allow one of its buses to be used by another municipality. Compensation is not relevant.

There is no requirement that a school bus registered and garaged out-of-state, used for transportation of Vermont students, be registered in Vermont.

If the bus is garaged in Vermont it must be registered in Vermont. Vehicles incidentally in Vermont are not required to be registered in Vermont if they are here temporarily and will soon be returning to their home garage.

A DOT physical is good for up to two (2) years and will be accepted by DMV (including for testing purposes) as long as valid, regardless of issue and expiration date.

For a Type I school bus: No.

For a Type II school bus: Yes.

Yes. They don't need to be accompanied by a licensed CDL operator with an "S" endorsement. School bus signs and lights do not need to be covered.

School contractors need to be in compliance with all CDL driver qualification requirements and regulations (FMCSR 391). It should be noted while there is an exemption for "to and from school" operation, there is no such exemption for trips performed by contractors. School transportation performed by a state or political subdivision of a state (i.e., municipalities) are exempt from some CDL requirements. For more information see FMCSR 390.3 (a), applicability, (f)(1)(2) exceptions (see interpretations for this section).

• Copies of physicals (to include vision and hearing screening),
• Initial 3-year driving record,
• Documentation indicating all students are participating in emergency evacuations twice a year, and
• Records of vehicle pre-trip inspections.

Contractors also need to be in compliance with all CDL driver qualification requirements and regulations (FMCSR 391).

Contact Vermont League of Cities and Towns, Vermont Student Transportation Association, Vermont Truck and Bus Association or Federal Motor Carrier Safety Administration.

Employers of drivers holding CDL's must have a drug testing program. Drivers holding CDL's are subject to random testing. These requirements do not impact individuals holding a Type II endorsement.